During the processing of the cnc metal laser cutting, it suddenly resets automatically, and the metal cutting machine returns to the origin point. There are stops, leaks, and chaos in the middle. At this time, don’t be panic. Please carefully follow the method below to eliminate the fault.

Cause of issue:

The main reason is that the control panel or the cable connection cable is loose, the motherboard or the grounding wire is unreliable, and the slight high voltage ignition has a fault. Method of exclusion:

1. Check the grounding condition of the metal cutter and measure whether the ground wire is up to standard (the resistance to ground should not exceed 5 ohms). The ground wire needs to be modified to meet the relevant standards.

2. Check if the connection cable is loose or the control panel button is in poor contact.

3. Whether the metal cutting machine is in the position or not.

4. Check if the computer has set screen saver or power save mode (such as system hibernation or power off the computer), cancel the above settings and change to "never".

5. Check whether Perfect Laser’s metal cutter software set "no output" or no setting such as engraving mode.

6. Check if the original graphics have errors, such as crosses, unclosed, missing strokes, etc., to correct errors in the graphics. Do the output test again.

7. If you use Wentai output, check if the path calculation is normal. Re-register or install Wentai, sometimes you need to reinstall the system.

8. If the graphic output in other formats has no problem, it indicates that the graphic is wrong, and you need to re-output or re-create the graphic.

9. Check if the laser tube or laser power supply has a spark.

10. If the cnc metal laser cutting machine problem still exists, replace the motherboard and computer test.