How to use it when the laser engraving machine is used as a manual guide for acrylic automatic slotting machine?
The use of plastic materials such as acrylic or PVC to cut into the edge of the luminous word to carry out the edge of the luminous word is a common method of acrylic luminous characters such as acrylic blister letters and whole body illuminating words. The cost of the rim is lower, it is easy to work and can be processed as long as it is equipped with a laser engraving machine.
However, the use of materials such as acrylic or PVC to cut into the edge of the luminous word edge has a big disadvantage, the processing efficiency is too low, it is mainly reflected in:
1. The edge of the luminous word is usually thicker, so the bending of the edge strip is a big problem. If it is not slotted, the angle of the curved corner is too large to look good. At the same time, due to the special nature of acrylic, heating is required when bending, and when bending is performed without slotting, the position of the bending is difficult to control accurately.
2. Although the slotting of the acrylic edge is a very good choice, due to the lack of suitable acrylic edge stripping equipment, the acrylic slotting work is a large project. Users usually only use the scribing on the side strips and then use the engraver to slot. The efficiency of doing so is undoubtedly very low.
In view of the above considerations, and also in the strong demand of the majority of China Perfect Laser customers, V1.6 integrates the “Acrylic Edge Strip Automatic Slotting” module in the auxiliary system software to automatically generate the grooved position and edge strip according to the outline of the word. The size is directly output as a DXF graphic, so that the edge strip and the groove can be directly carved out using a laser engraving machine. It has the advantages of high processing precision, high speed and high efficiency. It is an indispensable tool for the edge of Acrylic.
The specific use of this module is as follows:
1, open the file
2, configuration cut point
3, generate internal and external corners
4, set the acrylic slot automatically slotting parameters and output side strips and slotted maps
When only the outer corner groove and the inner corner groove are selected, only the line segment of the milling groove is generated. The edge frame rectangle is not, so that all the slotted segments can be selected, and the groove depth is set to be engraved;
When only the sidebar rectangle is selected, only the sidebar rectangle is generated.
It is easy to set the depth and engrave and cut a single edge strip
When the inner and outer corner serial number identifier is selected, a thumbnail of the outline is generated as well as the serial number of the inner and outer corner points of each slotted position. This option is used for the edge search and the position of the edge bar.
When only the outer corner slot and the inner corner slot are selected, The output lines can be directly selected and engraved.
When only the sidebar rectangle is selected, only the sidebar rectangle is generated, which is convenient for setting the depth and engraving each edge.
When the inner and outer corner number identification is selected, a thumbnail of the outline and a serial number of the inner and outer corner points of each slotted position are generated. This option is used for the edge search and the position of the edge bar.
Contact Person: Ms. Helen
Tel: + 0086-13971470845